How to Build a Robot

abhimanyu projects
Jan 01, 2013 Posted by Abhimanyu

How to Build a Robot

Jan 01, 2013 Posted by Abhi Raj

It is now time to show you a new version of this wonderful robot. This new version is much easier to build and fool proof!

The beetle robot (Beetle bot), is a very simple and efficient robot that use no electronics component to avoid obstacle in his path. It use two SPDT switch to avoid obstacles by reversing the opposite motor to pivote and free himself. There is no silicon chip, that is, no integrated circuit, no transistor, no resistor, capacitor, etc.

This mean very cheap to build!
beetle_robot_v2_2007_MAKE_ 113.jpg


beetle_robot_v2_2007_MAKE_ 044.jpg

beetle_robot_v2_2007_MAKE_ 039.jpg


Items for the robot:

2 x 1,5V motors
2 x SPDT ( single pole double throw ) switches with a metal lever
2 x AA or AAA battery
2 x Terminal connector ( see picture )
1 x AA or AAA battery holder
1 x Plastic or wooden pearl ( Spherical bead )
1 x 1 inch x 3 inch piece of metal or aluminum
1 x Toggle switch for the on/off switchs

Paper clips big and small

2 feets of wires around 22/24 Gauge size
Heat shrink that will fit over the motor shaft and some that will fit over the terminal connector
Electric tape and masking tape

Items for the body shell :

Round plastic lid to make the shell of the robot
Some spray can paint, the colour you want.
Clear varnish
Autobody filler putty or epoxy glue
2 x Small magnets to attach shell to body.

You need some 1,5Volts motor, not 3V or no event 12V!!

Each motors are powered by a single AA battery. You will drain your battery if you use a bigger motor. You can find them in toys or even at your local dollarrama, in little car, fans, etc! ( beware, they might really suck you battery down )

the recommended tools for this project:

1 x safety glasses!!
1 x soldering iron
1 x glue gun
1 x wire strippers
1 x side cutter
1 x scissors, knife, x-acto, etc